Highland 1100500 Aluminum Ramp Top and Bottom Kit

 (9 customer reviews)

This kit is top quality and the price was unbeatable. I opted for the wider set, 1100500, (this kit takes a 2 x 12 plank as opposed to a 2 x 8) to have a greater surface area to load equipment without worrying about being too close to the edges. Both top and bottom pieces are high quality and they mate up perfectly with lumberyard stock. These Highland ramp tips are built to last a lifetime.

I used these with kiln-dried 2x12 from Home Depot. I suggest you be patient and look for light-weight, well dried lumber. It will make it easier for you to handle. Pressure treated boards will be quite heavy after you've added the end pieces.

For easier handling, you may want to cut 1" x 5" handle holes near the center of the boards (leave 1-1/2" of material on the outer edge). I say near the center because you should temporarily afix the end pieces on the lumber first and then determine the true center based on weight. Then you can cut your handle holes. Otherwise, the boards will not be balanced when carrying them.

If this doesn't make sense, just cut the handle holes about 1" from board center toward the heavier end piece - that should take care of the weight balance. You may want to sand the handle hole edges for a smooth handle finish.

I did a lot of looking on-line before deciding to buy this product, and I'm happy with my decision.
Good product, good price, and delivered in a timely manner.